Machine Table
| Workpiece name : | machine table |
| Workpiece material : | HT250 |
| Workpiece hardness : | HRC60 (After surface hardening) |
| Machining position : | milling table surface |
| Machining type : | rough milling |
| Inserts grade : | CNS3030 |
| Insert specification : | SNEN1207ENS-M08 |
| Cutting type : | Dry cutting |
| Cutting parameters : | Vc=185m/min ap=1.5mm fz = 0.1mm/z |
| PCD cutting tools : | The efficiency is promoted by 300% |
| The cost is reduced by 25% |
| CUTTING TOOL CONTRAST | CUTTING SPEED VC(M/MIN) | EFFICIENCY (S/PCS) | LIFE (PCS/EDGE) |
| Grinding | 35 | 1 | 100% |
| iSC CNS3030 | 185 | 0.25 | 75% |
| Workpiece name : | machine table |
| Workpiece material : | HT300 |
| Workpiece hardness : | HB190-220 |
| Machining position : | milling table surface |
| Machining type : | finish-milling |
| Inserts grade : | CNS3030 |
| Insert specification : | SNEN090412ENS-M08 |
| Cutting type : | Dry cutting |
| Cutting parameters : | Vc=780m/min ap=0.2mm F= 2500mm/min |
| PCD cutting tools : | The efficiency is promoted by 31% |
| The cost is reduced by 50% |
| CUTTING TOOL CONTRAST | CUTTING SPEED VC(M/MIN) | EFFICIENCY (S/PCS) | LIFE (PCS/EDGE) |
| Grinding | 35 | 16 | 100% |
| iSC CNS3030 | 40 | 0.5 | 50% |
